My 6600xt is on windows but had the same issue as you where i only got 400mhs for ton… for some reason the card wasn’t pulling much power (90w) and now its back up at 1600mhs for ton and 120w
I restarted my pc and it was solved, i think my card was somehow power limited
You should be getting 32mh eth and 1600mh ton with these settings
I did that and activated all. It finally kicked in with all needed. Still dont get it how I can get higher hash rate on them.
I do wonder as the reduced settings with 2.3GH and minimal increase of heat and noise it seems to generating more value for £££ them heat the rig with higher memory MHz and try to get it to higher earning but bigger cost due to electricity useage.
Thanks for sharing this. I went ahead and tried your specs. Fantastic results. I wish I could push the TON’s up to 4 GH/s for each XT’s but how do I go about that without justifying ETH’s hashrate?
Agreed. If I reduce power the hashing for TON drops considerably. Luckily I’m not paying for electricity at this apartment condo that I live in. Any suggestions?
You have to make sure your using the correct address with port and all that to use the global callback %xyz% values. Simplifies things for multiple rigs instead of having to do all the config manually
Copy that. I’m all for less is more approach. Will try again with the flight sheet/configuration this weekend and report back. Thanks for your encouragements!
If you get stuck or need any examples of working configs let me know, make sure to reply to my comment or @ me for quicker response, I see indirect replies eventually but don’t get notified always for them.