Nowadays I am using binance pool on one of my rigs. I do not know why are some shares respond time is longer than 1000 ms. Unfortunately the team red miner is disconnects from the pool, and connects back but with another address (or port in this case).
When the miner starts it shows up the current value is --pool_share_limit_ms=1000. team red miner usage.txt
Where can I increase/modify this setting?
Did you find a solution? Same prob 
Probably a workaround
I am using teamredminer with the following inital settings:
–pool_share_limit_ms=5000
you can set this value under the miner configuration
hello vektor, I just saw an orientation for your solution to this problem, but where exactly do I place this configuration? pool_share_limit_ms = 5000
Thanks a lot for the help.
Hi Darknatus,
You are in good place, please see attached my configuration
After this, you have to see on the console the new settings every time when the miner (re)starts
our vektor, how amazing you are, thank you very much for your help, and especially for the print that made it very clear where I should add this configuration.
And just one detail my month is very bad, to the point of over 5000.
I really don’t know what is happening at binance because sometimes the same port is good and sometime is not. I’m using only the 3333 and 443 ports. There others seems to be dead, actually the miner client said unable to connect or something else like this.
Be aware to set the “pool_share_limits_ms” too high, because it can also be a reason to loose a part of your profit. BTW the screenshots what you attached is made earlier than you were set the parameter up right? I mean on the console shows (1610 ms > 1000 ms) , it comes from the original settings. If you put the higher “pool_share_limits_ms” to your config, you have to see the following for example 13200 ms > 5000 ms instead of 1000 ms.
thanks for the reply vektor, the binance pool is really having a problem.
And really the prints were taken before I programmed. thank you very much for the teachings vektor, and success in your mining.
Tengo el mismo problema en Binance el dia de ayer recibi Eth 0.0021 y hoy tengo un estimado de Eth 0.00093 en el puerto 443
Tengo el mismo problema que está en su pantalla.
