Some very nube stuff but can’t find discussion,
I found the dd clone commands on install page and found this can also be used to clone using dd command from flashed usb to ssd, however, I have question and issue on geting started.
procedure? do I just let hiveos load on usb then break to prompt with ctrl-c then run fdisk -l from here to id devices?
fdisk -l returns several partitions on usb, this wasn’t shown in install page example. so I assume all 3 partitions will get cloned to m2 ssd and that’s ok?
issue - fdisk -l doesn’t list m2 ssd, I’ve not formatted m2 ssd that’s probably a prerequiisite, but how can I format from usb command like if device is not detected?
Thanks for your reply, I failed to mention SSD is NVMe and did a bunch of research on that to confirm biostar BT360 D+ supported it, then went back and found I now see it with fdisk -l, I think I was misreading the screen output looking for an SDx name but it showed as nvmex at top of log output, I was thinking it would be listed after the SDA (usb) drive but it was listerd first, getting really fast performance on the Hiveos load routine, the NVMe’s were probably overkill but they were cheap enough at Best Buy so I grabbed them.