So I’m bringing some of my old GPUs back from the dead. It’s been about 3 years or so since I had them running. I did a little research and read that these cards worked well with HiveOS and Phoenix Miner. I went ahead and installed those and fired the AMD puppies up. To my dismay, I’m not getting anywhere near the hash rate I used to AND I’m now getting some fun errors. Since it’s been so long, I’ve forgotten a lot and am pretty much back to newbie miner status. I’m only getting like 3MH on the first card and that’s it. Yup, my 4 GPU set up is only spitting out 3MH on my first GPU slot. I don’t quite know the right overlcock settings and I’m getting both GPU fault 147 and 146 errors. I’m a mess basically. Any help would be greatly appreciated.
Attaching screenshot if it helps…
