I was running 3 different miners and all 3 were mining with one 3060TI card on each miner at 46MHS using NBMINER 39.7 + VNIDIA DRIVERS 495.44 + HIVE OS VER 0.6-208@210818
Well I pulled 3 cards out of the other 2 rigs and put them all into 1 rig and have set up the EXACT same clock settings that I had running with all cards at 46MHS and now they are all only performing and 38MHS each … and always dropping in and out of LHS LOCK MODE!
This is absolutely time consuming and soooo frustrating. WHYYYYY!!!
ok well since I am talking to myself… I have made a few tweaks in the BIOS as well . seems to be holding together so far … bee n ethe longest I have been able run it without hanging … over an hour now … so fingers crossed.
STill having problems… system has been off and on all date and have lost about 3 hours of running time for no apparent reason. Just uploaded latest HIVEOS and NVIDIA drivers… will see how this goes.
Your kernel is not the latest and the included drivers would be:
If you want to run on the latest platform, you’ll want to launch the hive replace command from Hive Shell, then disk expand, update your password, etc.
I am guessing you are still running HiveOS off the 120GB drive?
Did you run disk expand command after the update?
Did you update your password to match your rig.conf?
Your overclocks are likely set up against the later drivers you were running. Might need some tweaks or upgrade the drivers like you have in the past, on a newer and current kernel.
FWIW: There is a later BIOS for your Motherboard as well. Have one myself. Quite a source of frustration at times under more than one OS.
ok. I tried to expand my drive but it failed and corrupted the drive. So I took the drive out and started fresh. got the system back up and running and it had some weird glitch where it went to full power, I have never heard my server PSU wind up so much, I thought the fans were going to blow up!
Anyway after a couple of reboots, it settled down and the system has been up for over 13 hours with only 5mins down time. I must have done something because I notice it has 107GB of free space on the drive now.
That space will give you options to turn on logs for review over time, catch errors, and things as they are occurring. It will be very helpful with a group of GPUs that size.
You efforts were worthwhile
Not sure about the power spiking. A fresh load might have taken awhile to back down the power consumption of GPUs, other assets. Purely a guess.
Note: It looks like you are at 11 GPUs now, memory(RAM) is getting low. If you have problems adding 12 and 13 GPU, check your memory.
I think I am at the full capacity of this rig as I have a 1200w Server PSU and an 850w ATX sharing the load. currently drawing 1.674W at the wall all up. So am running at about 80% load.
I looked up the latest Bios versions of the H110 BTC PRO + and I am running the latest version where it is just adding the PCIE slot detection function, which is faulty anyway as it shows up as red on some of my Risers but they work fine.
am still getting periods where the miner looks like it has shut down or stopped hashing but no where near what it was doing. Logs seem clean from what I can tell
