Well I’ve had my mining rig up and running for a few days now its been stable.
I was using hashrate.no for the OC’s.
Using LOL miner
I’m pulling more wattage than what they list for the given cards / OC?
As you can see my 3070’s are at the given hashrate of 461 yet pulling 65 to 70 watts, hashrate.no says should be around 50. Is there a setting I’m missing?
I adjusted memory to lock it at lowest, and the oc’s are put in manually for each card, not in the miner extra commands because all cards are using the same flightsheet.
Any advice?
Locked core + core offset will get you slightly higher hash but not lower power draw. You’ll need to do that in the miner config and have 525.xx drivers or newer installed
Or does it HAVE to be in miner?
How can I do that with multiple cards from different mfr in same rig on same flight sheet?
Individual flight sheet for each card?
Thanks!
You can only run 1 flight sheet per rig at a time. Miner config will vary miner to miner, typically comma separated values for different cards but you’d need to check your miners readme.
In the hive gui you can’t set locked and offset, only one or the other.
I guess I’m confused on this then
Do I need to put the ocs in the miner extra coments AND the cards ocs? Hashrate.no shows core lock AND core offset. Meaning has too have both?