"Restart miner" command does not work in ASIC HUB

Hello, I have just installed ASIC HUB software and added a couple of S19J pro miners to it. I am very interested in the Watchdog timer function but I have tested "Restart miner "command and it has not worked.
I get the message that this command is not compatible with the miner.

Any idea why this command doen´t work? This ASIC miner appears as compatible with ASIC HUB software in the web page.

Thanks!

Asic hub works with many firmwares, including the stock fw. Unfortunately the miner restart functionality isn’t something offered on the stock firmware, however the reboot function should work and may only take a few seconds more than a miner restart would.

:ok_hand: thanks

Thanks for your answer. You are right, Reboot command works even with stock FW.

Now I am trying to use the Hashrate watchdog to Reboot the miner if hashrate dropd below 50% of nominal value. For the moment I have not been able to get it working. Do I need to use a flight sheet in the miner if I only want to use the Hashrate watchdog to reboot it?

You should have a flight sheet applied and watchdog enabled. If needed you can post screenshots and I can tell you if I see anything out of place

Thanks! I have applied a flight sheet and it s working right now.

1 Like

This topic was automatically closed 416 days after the last reply. New replies are no longer allowed.