Hello. My EVGA RTX 3070 XC3 is getting 2 invalid shares / 24 hours even at stock speeds. I am wired in with a gigabit switch. Using T-rex miner.
I found this in the example config and it seems to have fixed it
// DAG build mode. 0 - auto, 1 - default, 2 - recommended for 30xx cards
“dag-build-mode”: 0,
i have the same probleme with mr600 switch, bad hashrate and higher invalid share, the solution, all my rig is on my box^^
I found this in the example config and it seems to have fixed it.
// DAG build mode. 0 - auto, 1 - default, 2 - recommended for 30xx cards
“dag-build-mode”: 0,
I have the same problem, I am in doubt where exactly should I add these settings?
Add: “–dag-build-mode 2” (no quotes) to the end of the .BAT file you are using.
I’m using hiveos, so I added the parameter to my Flight Sheets:
Ex. For 6 RTX 30xx video cards
It is working so far without any share rejected
I am using T-rex miner. I wish you good luck to solving your problems.
I’m confused - for 30xx cards,
Is it “dag-build-mode”:“2” or “dag-build-mode”:“0” for them?
I assume you are using T-Rex 20 or higher. The only thing worked for me was T-Rex 19.5 Cuda-111. No invalid share so far with three 3070s.
“dag-build-mode”:“2” for RTX 30XX cards.
Are you using Hive? The red circles only appeared in Hive as of v20+ of T-REX,
Not sure if this was a bug now fixed in V20 though.
On 19.5 Cuda-111 check on pool if you’re getting invalids, if you are then likley the bug was fixed in Hive causing them to display red circles.
That’s my guess anyway.
@NoNameCola does the Automatic mode just choose “2” anyway for 30xx?
This topic was automatically closed 416 days after the last reply. New replies are no longer allowed.
