Stuck in "GPU0 will be paused again for clean dual mode calibration"; no hash rate, error fan pct

I have four 3070Ti cards used for dual mining ETHTON. Everything seemed no issues for two weeks but then one of the 3070ti card showed error like below:

I suspected Riser so I swapped to new one but still the same
I have referred the previous post from HIVEOS forum, there are a few suggestion to lower my OC setting perhaps the OC settings were agressive.
Even so, it still remains the same until now.

Post a screenshot of your worker overview screen


Hi Keaton,
Thanks for the response,
The image above is what you are looking for, is it correct?
Sorry for late reply, was off the grid for a few days,

Click on the rig name, then show the whole screen on the overview tab

This topic was automatically closed 416 days after the last reply. New replies are no longer allowed.